jibbs
Member
My brother and I just into reloading and have had a problem with our powder dispenser. When I do I check every 5th one too make sure its metering properly, my brother does not...
I had him run me 50 .45 acp, Frontier 230 RN, CCI primer, 10.4 gr. AA#7 in new starline brass (not +p) seated to 1.233 oal. Well he checked the powder at number 50 when he ran them all and it was dishing out 11.4. This is 0.4-0.8 grs over what the max load is depending on the book. I have no problem redoing them all as we cannot tell where the problem occurred.
I shoot them out of a Glock 30 and think that it isn't too much of an issue, but would like to see what experienced reloaders have to say. Again, not a big deal if we have to redo, just willing to give it a try if it is safe enough. Thanks in advance.
I had him run me 50 .45 acp, Frontier 230 RN, CCI primer, 10.4 gr. AA#7 in new starline brass (not +p) seated to 1.233 oal. Well he checked the powder at number 50 when he ran them all and it was dishing out 11.4. This is 0.4-0.8 grs over what the max load is depending on the book. I have no problem redoing them all as we cannot tell where the problem occurred.
I shoot them out of a Glock 30 and think that it isn't too much of an issue, but would like to see what experienced reloaders have to say. Again, not a big deal if we have to redo, just willing to give it a try if it is safe enough. Thanks in advance.