Ruger PC 9 Trigger

[Jayhawker]

Hello:

My PC 9 is dependable and dead-on accurate but is there anything to be done about a very hard pulling trigger?

Thanks for any help.

Pete

 

[PO2Hammer]

without a gunsmith, polishing all the safety surfaces will help. I don't know what threy're called, but the levers in the roof of the receiver can be removed and polished.
My first PC9 had a tough trigger, my second one is very nice.
I've noticed the saftey levers are much shinyer (why can't I spell) on the new one.
Also a synthetic grease on all moving parts of the trigger system will help.
Is it new?
Strip it down and blow all the factory oil out with gunscrubber. 'Paint' the surfaces in the trigger group with synthetic grease, I use lithium grease, good slick stuff that stays put.