Recently I posted about my SP101 which had been misplaced and was covered with dirt. The trigger, hammer, and cylinder were frozen up. I received several good suggestions from that post. I used Liquid Wrench and finally got the trigger and hammer to move enough that I could rotate the cylinder which is loaded. However, I wasn't able to unlatch the crane. The latch is frozen.
I've removed the hammer assembly but can't get the trigger guard assembly off because I can't hold down the release plunger and manipulate the assembly at the same time. I don't know if removing the trigger guard assembly will be of any benefit in getting the crane latch loose.
Any suggestions on how to release the crane will be most welcome.
Thanks!
I've removed the hammer assembly but can't get the trigger guard assembly off because I can't hold down the release plunger and manipulate the assembly at the same time. I don't know if removing the trigger guard assembly will be of any benefit in getting the crane latch loose.
Any suggestions on how to release the crane will be most welcome.
Thanks!