Pumpkinheaver
Member
I've fired tons of this stuff in 7.62X39, 9mm, .357 .223 and .45acp. Never had any problem with it. I havn't used any lately so maybe this is a new QC issue with them?
S&B Ammo
- Thread starter Nightcrawler
- Start date
- Status
PaulBk
Member
S&B is all I use in my .32ACP. A few hundred rounds without a failure of any kind.
-PB
-PB
S&B is great stuff. It works especially well in CZ's (imagine that 
). Accurate and hotter than most US manufactured equivalents. Good quality brass whose only fault is the primer pockets are a bit on the small side (which means the occasional flipped primer when reloading).
But lately here in OKC the supply has been limited for some reason.
). Accurate and hotter than most US manufactured equivalents. Good quality brass whose only fault is the primer pockets are a bit on the small side (which means the occasional flipped primer when reloading).But lately here in OKC the supply has been limited for some reason.
taz-2005
Member
I have used 45 apc, 9mm. 38 spl .357 mag 40 s&w no problems at all in any of my firearms.
fastbolt
Member
The most recent experience which comes to mind was during a CCW class we were teaching the other night ...
One of the licensees brought a new box of S&B .38 Spl ammunition to use during qualification. After several repeated failures-to-ignite occurred in his revolver, all of which involved some rather impressively well-struck, deeply indented primer cups, he switched to a different brand of ammunition and completed his qualification. He 'donated' the remaining unused box of it to us, obviously not wishing to keep it.
One of the licensees brought a new box of S&B .38 Spl ammunition to use during qualification. After several repeated failures-to-ignite occurred in his revolver, all of which involved some rather impressively well-struck, deeply indented primer cups, he switched to a different brand of ammunition and completed his qualification. He 'donated' the remaining unused box of it to us, obviously not wishing to keep it.
- Status
