hey there
i have been loading a batch of 45 auto with missouri bullet co 200 grain lswc bulluts
and with a rcbs press ,lee seating die and as uniform of a pull as i can i keep getting different caol measurements
after examining everything i think i may have found the problem but not sure , also i am not sure how to fix it
my lee die seems to be made for a round nose bullet, the part of the die that pushes the bullet is rounded , the end of my lswc bullets are flat, i would think this would be the weak link or the best possible spot in the set up for inconsistancy
are there certain dies you guys recommend for flat nose bullets, am i barking up the wrong tree
do i need to change from lee dies
how much defference in coal is tollerable from a safety stand point
thanks for your help
i have been loading a batch of 45 auto with missouri bullet co 200 grain lswc bulluts
and with a rcbs press ,lee seating die and as uniform of a pull as i can i keep getting different caol measurements
after examining everything i think i may have found the problem but not sure , also i am not sure how to fix it
my lee die seems to be made for a round nose bullet, the part of the die that pushes the bullet is rounded , the end of my lswc bullets are flat, i would think this would be the weak link or the best possible spot in the set up for inconsistancy
are there certain dies you guys recommend for flat nose bullets, am i barking up the wrong tree
do i need to change from lee dies
how much defference in coal is tollerable from a safety stand point
thanks for your help