You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Springfield 67h
- Thread starter sefuller
- Start date
- Status
-
Not open for further replies.
rcmodel
Member in memoriam
Take the trigger group out of the receiver and clean it.
Also take the bolt out and check for a broken or stuck firing pin sticking out of the breech face.
And while doing that, look for broken or worn parts or springs.
On the other hand, if you need that advice, you should take it to a gunsmith for repair.
Taking one apart that far is not for the amature kitchen table novice gunsmith.
rc
Also take the bolt out and check for a broken or stuck firing pin sticking out of the breech face.
And while doing that, look for broken or worn parts or springs.
On the other hand, if you need that advice, you should take it to a gunsmith for repair.
Taking one apart that far is not for the amature kitchen table novice gunsmith.
rc
- Status
-
Not open for further replies.