Taurus Millenium Pro?

Status
Not open for further replies.

Sisco

Member
Joined
Dec 24, 2002
Messages
2,775
Location
KS
Would like some opinons about this model as a carry weapon; dependability accuracy etc.
 
My wife fired hers at the range yesterday and ran 100 rnds thru it with no problems. Hit everything she aimed at. Absolutely loves the gun. We have never had a problem with hers. I think it's a well made gun for the money, and fairly accurate as well. The price is creeping up though. If I could get it away from her, I would carry it myself.
 
I remember a bunch of people on gunreview.com claimed the frame cacked on the 40sw version a couple years ago when they came out. I'm not sure if its been remedied. Good luck
 
I have 2 PT-145 Pro models, DAO and the new SA/DA.

The DAO one has eaten everything I fed it (about 1k+ rounds so far), and is pretty dang accurate (though I 'm not as good with the double action trigger as I could be). No weirdnesses at all except 2 FTF rounds early on that fired on second strike.

Just put 400 rounds in the SA for initial break in (Winchester white box- every one went bang), and am feeling pretty happy with it, especially the SA trigger. Still on the fence about the new Heinie straight-eight sights though.

Had 4 failures to feed- 2 with the new mags in the first number of rounds I was shooting, and the other 2 were definitely from my really bad limp-wristing in single handed shooting.
But that was initially- no problems at all after the first 40 rds, so I think the first two were a break in thing- I'd trust it.

So, 2 Mil pros of 2 generations, and no dramas so far. :)

I really like them quite a bit!

Sadly, I have no experience with carry yet, but I hope to move and I'll know then!
 
My daily carry for the past year has been a PT-111 Mil Pro. I have probably about 1600-1800 rounds through it without a failure. After my last range session with it, I noticed that the front sight was a little loose, but I corrected it with a little lock-tight. It is easily concealed in an IWB holster. I added a hogue slip on finger groove grip, which feels a lot better in my hand. The trigger is the only con. It takes some getting used to.
 
Guess I should clarify a bit, I'm looking at the PT145 - DA/SA in 45acp. Haven't actually had my hands on one yet.
Normally I'm a 1911 kinda guy but I'm looking at something smaller, lighter and easier to carry that won't put a strain on my budget.
 
Last edited:
I like mine

DAO takes a little getting used to...

conceals quite well IWB...but not nearly as skinny as a Kahr...

reliable....

accurate (at least at personal protection ranges)...

had it for 7 month with ~ 1,000 rounds through it.

I carry one in the pipe with the manual safety on, so I wish I had the SA version (wasn't out when I bought mine) but the DAO trigger is pretty smooth.

It's a very good gun for the money.
 
I have a PT-140 Mil Pro that is my primary carry weapon. Shoots great, doesn't like 165 gr but has never had a failure with 180grn and above. The trigger gets better and better. In fact, its the best DAO gun I've ever shot. Its got a manual safety and a long smooth pull, perfect, IMHO, for concealed carry.
 
I have a 745 DAO. Perfect, to me. Tiny, especially for a .45. Reliable, accurate. What else could you want in a CCW? Mine usually has Ranger RA45T 230gr in it. Never feel like you don't have enough gun with you.

I actually wanted the DAO, since it's basically an automatic that's as safe as a revolver. The 145 seemed too thick, since it's a doublestack. The 745 is the single version. Same slide, thinner grip. Trijicon three-dots meant for the 145 will fit it for the DAO. No idea about the new one with the straight-eights.

I chose it over the Kahrs because too many people on forums were reporting break-in issues and just broken Kahrs, and that's unacceptable for CCW, IMO.

And nope. Lots of holsters out there, both custom and general fit that hold it snugly. Plus they vanish into a Smartcarry.
 
I own a PT145 Mil Pro and love it. Dead reliable and easy and fun to shoot for a DAO. Somebody mentioned early models having frame cracking problems. I understand that was in the non-Pro versions of the PT145. The Pros are a later generation and have the bugs worked out.

Prices are creeping up, but Bud's Gun Shop has some of the best prices, when he has them in stock. Check back regularly, and I bet you can snag one for about $300 plus shipping.

http://www.budsgunshop.com/catalog/index.php/cPath/21_50_495

Lou
 
I took my new Taurus Millenium Pro PT145 to my usual indoor range today. Mine is the newest version that is advertised on the Taurus website as having a DA/SA trigger. In reality, it is always in SA mode unless there is a failure to fire, in which case the pistol's trigger goes into DA mode for a second (or third, etc.) strike on the same round. If the 'problem' round is ejected, the pistol resumes SA mode.

I do NOT ordinarily shoot factory ammunition at the range and today was no exception. I took a quantity of 3 different recipes from my personal handloads - 1. 200 grain LSWC bullet w/ 4.0 grains of Bullseye and a Federal primer, 2. 200 grain plated SWC bullet w/ 4.5 grains of Bullseye and a Federal primer & 3. 230 grain plated RN bullet w/ 5.0 grain of Bullseye and a Federal primer.

Out of a grand total of 150 rounds, the PT145 experienced 3 failures to feed. These all three occurred with recipe #2, above. This is not unusual since many of my guns are finicky about feeding the 200 grain SWC bullet profile. It is often necessary to adjust the COAL to the individual gun.

At 10 yards, I found that all rounds shot somewhat low (between 1.5 - 3 inches), but pretty good regarding windage. Since it is basically accepted that heavier bullets shoot higher, it surprised me a little that recipe #1 shot closest to POA followed by #2 and then #3. As time permits, I will experiment with other bullet/powder combinations and try to improve upon these results. Nevertheless, I was satisfied with this level of accuracy for a handgun designed for personal protection.

At $310 plus tax, I think these guns are a pretty good value.

Here's mine:

DSCN0654.jpg
 
I'm convinced. These replies plus the searching I've done on other sites give pretty positive reaction to the M.P.
Taurus' website lists two shops in my area as dealers, they're not my favorite places but I'm going to go see if they have one in stock.
 
I own the Mil pro111 and the pro145. My wife carries the 9mm and I carried the 145 up untill i got the 24/7 Pro. They are both great pistols and I have never had a problem with either. Get one and you will be in love!:D
 
I've had my taurus mil-pro 40 since January '06 and I've got about 800 rounds out of it, mostly Fiocchi FMJ. I've had zero failures, the gun is accurate, fits my hand great and is comfortable to shoot. I belive this is one of the best guns Taurus has ever made. I personally like the DAO trigger on mine, its a tad heavy, but its consistent and smooth, it really smooths out after 500 rounds. This gun will go neck and neck with my XD in terms of accuracy and reliability. I'd 100% recommend it.
 
I just sold a relatively new PRO111 and replaced it with a CZ PCR.

The PRO111 was 100% reliable, but it was not very accurate for me and just felt wrong in my hand!

This is just me and you may find the pistol feels good in your hand.
 
I took a real chance buying the Taurus PT-145 Millennium Pro after reading about all the previous versions problems. Well that chance has paid off big time. I wanted a BUG (Back Up Gun) in 45acp since that is the caliber I carry. I looked a bunch of guns......and then went to the range with a buddy that had the MilPro. I shot two mags full and left the range, drove to the local convention center, where there was a gun shoe going on and walked out 15 minutes later with my own and an extra mag. It has been my constant companion since. It is a BUG 85% of the time and a primary carry weapon the other 15%. It has serves up over 4000 230gr. manstoppers without so much as a hiccupp. Some folks don't like the double action trigger pull. They say its long and gritty, but I am an old revolver shooter and mine has become buttery smooth after just a few thoushand rounds. It is easy to control even as small as it is and it is very accurate. I can highly recommend this little hand cannon.

I have seen several holsters from most of the major manufacturers. I have two Galcos for mine. One is IWB and the other is for OWB wear. I carry it most of the time in my front right pocket in my dress pants in an Uncle Mikes Pocket Holster. Any custom holster maker can make you a holster as well.
 
My first contact with the Mil Pro PT145 was at the end of last year when I was looking for a compact .45 as a carry gun. A guy that was working in on of the shops I went into showed me one and I was impressed with how it felt in my hand. However, I snobbishly turned my nose up at it and went with a Glock 36. I ended uphaving issues with that gun, forced the dealer to replace it, then had extractor issues with the replacement.

I then bought a Glock 19 and a Glock 26, both of which I love, but I still wanted a little .45. Like bigmike45, I rolled the dice and finally bought a PT145 despite the reported issues with the older models with the attitude that I could afford to try it out since it was priced so well. After 300 rounds, it has been totally problem free and is the gun I carry on the road to work everyday. It also accompanies me on my nightly walks after supper and it is often the one that I keep out in the house at night.

Look like it's a keeper to me ;)
 
Status
Not open for further replies.
Back
Top