Strykervet
member
- Joined
- Nov 16, 2010
- Messages
- 1,610
I posted awhile back about using a cordless drill to make trimming brass on a RCBS hand lathe awhile back, just to find out others have been using the idea for some time. But it is still worthy to mention from time to time to save others extra work trimming until they can upgrade.
Another thing I forgot to mention was that I found inserting the primer pocket cleaning brush, which usually screws into a handle, into the chuck on my 18v DeWalt (it doesn't touch the threads) works MUCH faster and better. Just another time saver, and all the help you can get with all of the tedious steps of preparing brass, especially rifle brass, is worth it!
Oh yeah, forgot to mention but I should, if you attempt this be careful as always, and never use the drill at high speed. You can keep the drill set at high speed, but be easy on the trigger so it doesn't spin that fast. It doesn't take much using the drill to trim brass or clean primer pockets.
Another thing I forgot to mention was that I found inserting the primer pocket cleaning brush, which usually screws into a handle, into the chuck on my 18v DeWalt (it doesn't touch the threads) works MUCH faster and better. Just another time saver, and all the help you can get with all of the tedious steps of preparing brass, especially rifle brass, is worth it!
Oh yeah, forgot to mention but I should, if you attempt this be careful as always, and never use the drill at high speed. You can keep the drill set at high speed, but be easy on the trigger so it doesn't spin that fast. It doesn't take much using the drill to trim brass or clean primer pockets.