USA1 Billet Toolheads for 550 Dillon

Status
Not open for further replies.
Catpop

Catpop

Member
Joined
Dec 29, 2012
Messages
2,705
Location
Eastern NC
Does anyone have experience using these USA1 non-Dillon toolheads?
Any pros or cons?
Is fit as good as factory Dillon?
Thanks for help
 
I don't have any of the USA1 toolheads, but I do have a few of the Jofer USA (also on eBay) toolheads. They are CNC machined from 6061 bar stock, and anodized. The OEM Dillon toolheads are cast aluminum.

I would say that the aftermarket toolheads are probably higher quality than the OEM Dillon toolheads for about half the price.
 
Status
Not open for further replies.
Back
Top