-
-
MEHavey replied to the thread Looked at the New Ruger American II YUCK!.Is it rugged? Is it simple? Is it light? Is it carriable? (with the smaller magazine) Is the trigger any good? Does it fit the shooter... -
MEHavey replied to the thread Odd Annealing Question.Yes.... don't worry `bout it. Surprisingly -- as the brass ages/discolors w/ firing -- it will reappear. :thumbup:
-
MEHavey replied to the thread Beware of Vihtavuori Load Data..Ditto same S&W Model 60 3" 357Mag as Post #33 above This time using just-cast/coated/loaded Lym 358156 LSWC (Ray Thompson's 38/357...
-
MEHavey replied to the thread Beware of Vihtavuori Load Data..The Lee 358-158 has a nose that's much too short/shank much too long. Requires an OAL of 1.365 for crimp grove. Casting up some Lyman...
-
MEHavey replied to the thread Beware of Vihtavuori Load Data..The Lyman 358665 has roughly the same shank length inside the case as a Keith-type SWC. But I'll cast up some actual Keiths this evening...
-
MEHavey replied to the thread Beware of Vihtavuori Load Data..Ran, Loaded & fired effectively duplicate 38 Special combination this afternoon in: S&W Model 60 3" 357 Mag revolver Set QL to 3.5" to...
-
MEHavey replied to the thread Beware of Vihtavuori Load Data..Take a look again at https://www.vihtavuori.com/reloading-data/handgun-reloading/?cartridge=41 Are you running a jacketed/plated SWC...
-
MEHavey replied to the thread Gravity Chambering.Out of Curiosity.... What is the Canadian rule of checking the chamber ?
-
MEHavey replied to the thread Leading Problems.As noted above, put the gas check on to protect the smaller GC shank edges left exposed/unsealed
-
MEHavey replied to the thread Gravity Chambering.OOC . . . what is that ? :thumbdown:
-
MEHavey replied to the thread Sizing Belted Magnums or (How I stopped worrying and embraced the false shoulder).I could see a foreshortened case happening on firing IF . . . - The case/chamber was slick/lubed to where it didn't lock itself at front...
-
MEHavey replied to the thread Cutting Aluminum Cans.You can cut through the top/down into the side right at the pop top hole. Then just turn 90 degrees and cut the top off. No problemmo...
-
MEHavey replied to the thread Cutting Aluminum Cans.Plain old pair of scissors.
-
MEHavey replied to the thread rock salt: Lethal or not.Kinda impractical across the board.... https://www.theboxotruth.com/threads/the-box-o-truth-33-rock-salt-in-a-shotgun.357/...
-
MEHavey replied to the thread Should I lube before sizing these?.Powder Coating (the baked-on kind) is its own lube. Save in extraordinary circumstances, no sizing lube req'd using Lee sizers
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…