I'm looking for a new revolver to shoot 38 sp. wadcutters. I have been shooting 148gr. DBWC's in my 357 Vaquero's with good results. Will I get better results with a 38 special chambered gun ? I would like a gun with sights and 4 to 6 in. barrel. Any suggestions !
Steeltown
Anyone use Alumagrips on your Taurus PT1911 ? Just bought a Ruger MKIII Target with checkered Aluminum grips and really like the look and feel of them and I'm looking to get a set for my PT1911. The Ruger has Hogue grips but a quick check on the Hogue website says trimming may be needed to fit...
]I just got a deal on some 44 Mag. brass (free) and would like to work up a 44 Special type load in 44 Mag.cases. Meaning low recoil and Vol fps. somewhere from 750 to 1000 fps. Need a good "cowboy load" to run in my Winchester 94.
It can shoot both 44 Sp. and 44 Mag. but the Mag. cases run a...
Just got a Lyman # 55 powder measure and was wondering. What slide does the best job for small pistol loads ? I know the directions say to use the top small slide for small loads but do any of long time reloaders use it differently ?
Is the small slide the most consistant ? Does a small opening...
Just bought a Bair 130 SS press w/powder measure and 3 sets of Dies from
E-Bay for $66.00 with shipping. Powder measure is a small Bair model.
The dies are Bair 38sp,Lyman 357/38 and Lyman 9mm all have shell holders.
I do my reloading on a Dillon SDB and bought this to do small...
Hi All,
I was looking for some cheap 22 LR and found this and thought I would share with all of you ! It's called the Ammo Engine and may help some of you find what your looking for ! www.ammoengine.com
It works for rimfire , rifle and pistol ammo ! and it's easy !
Steeltown
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.