I have the new system and haven't had any problems at all.
At what point does it pop out of place, Is it on the ram up stroke to
get a new primer? If that's the case you may need to check your primer
punch to make sure its coming back out of the primer slide. If its sticking you
may need...
I thought I would pass along some info and part numbers(Not sure if its out there already). I had some thing lock up the primer punch holding it in place and locked up the primer slide.
Well that bent the primer cam rod. So I called hornady to get a replacement and found out that they had a...
I had the same problem as you. I call hornady and they sent me a new shell plate as they updated it. And this if for the number 16 shell plate
Here is the pic to show what they change.. Old shell plate is on the left, new on the right..
They change the radius on the edge of the shell...
Found this link on this forum or a different one, I just cant remember.
Here is something like the hornady lock ring. Just way cheaper.
http://www.fastenal.com/web/products/detail.ex?sku=0403243
Well I like mine, it took me a little time to get it setup. And I called hornady and got the new drop tube for the 40s&w. The part number on the shipping list is
#398302
I thought I would share my fix for the hornady lock & load ap,where the finished shell drop. When prepping 9mm brass I always had a problem of them going
under the ram. So this was my fix for that problem.
I have a few extras made, send me a pm or email
Thanks
Bobby
Its just a new alum part, No clear drop tube..
I already got it. Here is some pics of all 3 parts.
The part number on the shipping list is
#398302 Description= Tube funnel drop int ap.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.