Lock & load ap Drop ramp

[Cdstang]

I thought I would share my fix for the hornady lock & load ap,where the finished shell drop. When prepping 9mm brass I always had a problem of them going
under the ram. So this was my fix for that problem.







I have a few extras made, send me a pm or email
Thanks
Bobby

 

[Walkalong]

Very nice. Mine does fine with 9MM. Go figure. Did you attach it to the bin bracket so it stays put when you dump the bin?

 

[Cdstang]

For right now I have double sided tape holding it in place. But later on when I get more time I'll drill a hold and put a screw to hold it in place.

 

[GarySTL]

Slightly off topic, how do you like your case feeder? Was talking to a fellow today where I buy some of my supplies and he said he took his off because it was a PITA to adjust.

I'd been considering adding one to my LnL press.

 

[Cdstang]

Well I like mine, it took me a little time to get it setup. And I called hornady and got the new drop tube for the 40s&w. The part number on the shipping list is
#398302

 

[357Shooter]

Good Fix, I've had some 357 & 45ACP do the same, now I have another project today!
Thanks for the post!