I have replaced the trigger return spring and I am down to 2.35 lbs on the trigger pull. that is a big change! I think i will leave it there. I don't have a need to go lighter than that.
OK so i measured the trigger pull today without further adjustments it is at 4.04 lbs. All i have done so far is smoothed the edge where the trigger meets the sear. This happens to be one of the recommendations from rimfirecentral.com (thank you Bailey Boat) there were some other good ones i...
I have seen just a few people post on here about adjusting the Marlin .22lr bolt action rifle's t-900 trigger system and even fewer about the model 981T. Those that have had suggestions all say to buy the Rifle basics trigger. They have also noted that for the model 981T the safety won't work...
Thanks for the reply Smitty in CT . Yeah I should have guessed it was tasco. I looked up some reviews on this scope and there were some bad ones. some stuff about being too dark, but the most disturbing ones were about the scope losing its zero two days later. have you hear of anything like that...
I just bought a Mossberg .270 100 ATR it has a factory mounted Mossberg 3-9X scope on it. I have been looking for information about the scope but I can’t find anything. My question is “should I get a new scope?” my initial reaction to the scope was: “typical eye relief, typical low light...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.