Changed the extractor and think I have tension about right, will see how thing go tomorrow,
Discovered that a 1911 will apparently work fine with a firing pin spring in three pieces
(heck that might have had something to do with the failures to extract)
Thought I had changed that a while back but I might have messed up and put the old one back in.
Got the new extractor in, was very conservative on how much I bent it for tension the first time.
Still had a couple failures, took it out and gave it a bit more bend.
Ran some rounds, maybe a bit more bend. (going very little at a time)
Ran 500 rounds no issues after the third adjustment so I think I have it.
I would say if it behaves for another 1000 I have it taken care of.
Sure most of you would have got it right in one try.
First time I have messed with one though so happy I got it.
PS: It;s easier to put back together if I have my see up close glasses.
Left them and home and when working on it at the range the firing pin appeared to be about the same diameter as a .243 bullet. (fuzzy edges of course) Made it a bit trickier.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.