That's fantastic. I've had some minor issues with the primer shuttle getting hung up and that looks like it will solve it. Thank you for sharing SC Dave.
I installed the large primer feed for the first time and it would not feed a primer. I finally figured out that the top edge of the hole for the primer in the primer shuttle was not beveled at all. I worked that edge down a bit and it's running fine. The primers fit below flush in the shuttle. The next primer in the stack then is actually just slightly down into the shuttle, if the edge isn't relieved that next primer will jamb the system.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.