Hello
I"m still new to reloading (been reloading 223, 9mm, & 40sw)
I just received my dies for my 5.7x28
Here is my problem.
I'm wanting to use the same bullets in my 223 as my 5.7x28.
I like the 55gr load in my 223 so I wanted to use it in my 5.7x28 (as plinking ammo)
I am ordering some other grain bullets to use as hunting/percision with my 5.7 but only 50 at a time of them (I don't do it that often 50 will be a years worth of hunting ammo for me)
I have the following powders available
H335
#5
1680
IMR4198
I have noticed some of these used on the 5.7 but not with 55gr bullets.
I use CCI #400 primers.
If anyone can give me a good starting load to use with any/all these powders I would be very greatful. I have no idea what to start with on this load. (haven't found that much data on the 5.7 around)
I know AA has data listed for #5 but not for that grain bullet..
Thanks again
John
I"m still new to reloading (been reloading 223, 9mm, & 40sw)
I just received my dies for my 5.7x28
Here is my problem.
I'm wanting to use the same bullets in my 223 as my 5.7x28.
I like the 55gr load in my 223 so I wanted to use it in my 5.7x28 (as plinking ammo)
I am ordering some other grain bullets to use as hunting/percision with my 5.7 but only 50 at a time of them (I don't do it that often 50 will be a years worth of hunting ammo for me)
I have the following powders available
H335
#5
1680
IMR4198
I have noticed some of these used on the 5.7 but not with 55gr bullets.
I use CCI #400 primers.
If anyone can give me a good starting load to use with any/all these powders I would be very greatful. I have no idea what to start with on this load. (haven't found that much data on the 5.7 around)
I know AA has data listed for #5 but not for that grain bullet..
Thanks again
John
