Red Cent
Member
A buddy of mine has a Hi-Standard AR15. He installed a Bushmaster Competition Two Stage trigger kit. And it doesn't work.
With just the lower, you can cock the hammer and the trigger will not move except when you push it forward. When you push it forward, you "set" the trigger. At that point, it has a very light trigger and will drop the hammer normally.
And, cock the hammer, turn the selector from fire towards safe and just before the selector points to safe, the trigger will "set" and drop the hammer normally.
I have backed out the OT screw just a tad and I have backed the spring plunger out a tad also. Doing these items did not change the trigger.
In the fire position, I am aware of the AR's safety having the flat spot and rolling the selector to safe simply blocks the trigger. Thats the way the trigger feels when you first cock the hammer with safety off. I have watched the mechanism and it has not registered why the hammer moves a couple of hundreds of an inch when you push the trigger forward.
You can cock the hammer with the selector on safe or fire and you cannot drop the hammer with the trigger. You gotta push it forward or you can rotate the selector to safe and back and it will drop the hammer.
The directions does not mention anything about this. Simply tells you to install everything as you would a normal trigger except adjusting the plunger spring for the two stage and the OT adjustment.
Any clue?
With just the lower, you can cock the hammer and the trigger will not move except when you push it forward. When you push it forward, you "set" the trigger. At that point, it has a very light trigger and will drop the hammer normally.
And, cock the hammer, turn the selector from fire towards safe and just before the selector points to safe, the trigger will "set" and drop the hammer normally.
I have backed out the OT screw just a tad and I have backed the spring plunger out a tad also. Doing these items did not change the trigger.
In the fire position, I am aware of the AR's safety having the flat spot and rolling the selector to safe simply blocks the trigger. Thats the way the trigger feels when you first cock the hammer with safety off. I have watched the mechanism and it has not registered why the hammer moves a couple of hundreds of an inch when you push the trigger forward.
You can cock the hammer with the selector on safe or fire and you cannot drop the hammer with the trigger. You gotta push it forward or you can rotate the selector to safe and back and it will drop the hammer.
The directions does not mention anything about this. Simply tells you to install everything as you would a normal trigger except adjusting the plunger spring for the two stage and the OT adjustment.
Any clue?