Shak3s1977
Member
Dumb question, but I'd be dumber if I didn't ask and then screw up 100 rounds. My Dillon 550 is hanging up on the 45acp expander pretty bad today for some reason. I'm using wet tumbled brass and I know that's the main reason.( I did run 100 dry tumbled brass thru and it was much smoother.) I haven't had this problem before. I've had some rough runs, but this is crazy tonight.
I have 2 bottles of Dillon case lube that I've never used. Can I spray the cases and load them when they dry? Or will the lube contaminate the powder? I feel like I'm going to tear my arm out, when they get stuck on the die.
I did some googling first, but even the Dillon YouTube video say spray, wait to dry and then resize. They don't mention using it to make the press smoother when loading? Thanks for any replies as always.
I have 2 bottles of Dillon case lube that I've never used. Can I spray the cases and load them when they dry? Or will the lube contaminate the powder? I feel like I'm going to tear my arm out, when they get stuck on the die.
I did some googling first, but even the Dillon YouTube video say spray, wait to dry and then resize. They don't mention using it to make the press smoother when loading? Thanks for any replies as always.