Don Hume 001 Pocket Holster

[ruger1228]

Had anyone used this holster on the Colt Mustang? My question is: Will this holster work for the Sig P238?
Thanks in advance for the help
thom

 

[harmon rabb]

if it'll work for the colt mustang, it'll definitely work for the 238.

i'll ask, though, why you'd use a pocket holster with a slippery exterior. i actually stupidly bought a don hume pocket holster for my g27. while it's very nicely made, the holster comes out as well when i draw.

my cheapie desantis pocket holster stays in the pocket when i draw. better choice imo.

 

[ruger1228]

Thanks for the info. I'll have to check out the desantis
thom

 

[armoredman]

Mikas, GREAT pocket rig!

 

[The Lone Haranguer]

My question is: Will this holster work for the Sig P238?

I think the guns are close enough in dimensions that it would work. If it does not quite fit, you can lightly wet the holster, wrap the gun in plastic wrap or wax paper, stuff it in the holster and leave it until the holster dries.

i'll ask, though, why you'd use a pocket holster with a slippery exterior. i actually stupidly bought a don hume pocket holster for my g27. while it's very nicely made, the holster comes out as well when i draw.

You need to pull the holster up and to the rear to snag the hook on your pocket as you draw, thereby freeing the gun. I don't like this, either. There should be no special techniques or unnatural motions (that can be fumbled under stress) needed to draw. Also, too many holster makers think a pocket holster needs to fit tightly. It need not retain the gun (your pocket already does that), only keep it positioned in the pocket.

Mikas, GREAT pocket rig!

Agreed. It does not suffer from any of the above problems. Mika pocket holsters