1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Finally !!! I have a gun !!! I have a gun !!! And few questions too :)

Discussion in 'General Gun Discussions' started by armedpolak, Oct 4, 2006.

  1. armedpolak

    armedpolak member

    Here it goes! I picked up this fancy Beretta 90-Two F .40S&W this morning! Me so happy! My first handgun! I'm finally free of socialist NYC! I'm in freedom land Florida!

    So, about the cleaning... since I did it for the first time in my life today... I cleaned the damn thing for an hour :what: and I'm not sure if it's clean enough :uhoh:

    I followed the instructions, I field stripped it, cleaned the barrel with bronze brush and gun cleaning agent spray thing, then soft brush and a drop of oil, then cotton swab through it, finally barrel "snake". Came out a bit dirty, even after 5 minutes of cleaning ( I shot 450 rounds today ). Then, sprayed the slide and parts of frame with gun cleaning spray, waited 5 minutes, sprayed again and cleaned with soft brush. Repeated twice. I can still see few spots I couldn't reach with the tools I have: tiny little groves in the slide etc. I did the best I could.

    Then the part that made me wonder... oil :uhoh:

    I put total of maybe 6 to 8 tiny drops of oil in the gun. On barrel slide, triger, triger pull mechanism thing, mag release button, in front of trigger, and those two funny metal parts that stick out after field strip in front of the hammer.

    SO how much oil is too much??? I can see it dripping out along slide etc. Again, I put only about 7 tiny drops total. IS that OK???

    Attached Files:

  2. Geronimo45

    Geronimo45 Well-Known Member

    Too much oil? Nothing to worry about. Always have a little of that when I clean my gun. Lay it on a rag so that it doesn't stain anything and let it sit awhile.

    Nice gun. Welcome to the free world, komrade.
  3. SoundWave

    SoundWave Well-Known Member

    It should be fine. Nice gun by the way.
  4. CountGlockula

    CountGlockula Well-Known Member

    Great pics. Just wipe off the excess oil and you should be good to go.

    Great job on the Beretta. My hands are too small to hold a Beretta...that's why I chose a Glock.
  5. geekWithA.45

    geekWithA.45 Moderator Emeritus

    Congrats, and welcome to America!

    The sig armorer's manual gives good advice.

    A gun should be *visibly* lubricated, but the oil should not be so much as to be seen to flow with gravity.

    Guns don't come _completely_ clean, and they don't need to be. You only need to detail strip to components every so often.

    My advice on barrel cleaning is a dozen or so passes with a wet bore brush, followed by alternating wet and dry patches until the dry patch comes out pretty clean, but needn't be immaculate. The 2nd to final pass is an oiled patch, followed by one last dry patch to remove excess oil.
  6. JD_LION

    JD_LION Well-Known Member

    CONGRATULATIONS!!! Nice first choice you can't go wrong with Beretta.
    I like the dust cover over the picatinny rail. How do you like the Superluminova sights?
  7. FTF

    FTF member

    450 rounds your first day with it? Sounds like fun! Welcome to the club!

    Yeah, just wipe it clean. You don't want it dripping with oil, obviously. I usually wet my brush with breakfree CLP, scrub it down, wipe it off and then apply a nice coat of oil/lube where parts move or metal contacts metal. Make sure the slide rails are oiled, maybe a bit on the barrel... you're set. That pistol is hard to mess up.
  8. lionken07

    lionken07 Well-Known Member

    very nice gun!!

    I am too are one of the people who got out of NYC. Its like a jail cell there...:D
  9. JohnKSa

    JohnKSa Well-Known Member

    All my Beretta manuals have lubrication recommendations...as well as other useful information. ;)
  10. Prince Yamato

    Prince Yamato Well-Known Member

    Do as I do with my Beretta 92:

    after the gun is stripped:

    1) get can of Gun Scrubber and box of Q-tips.
    2) spray cotton part of q-tip.
    3) clean every nook and cranny until q-tips stay white
    4) use cheap walmart cleaning rod and cut up t-shirt to clean barrel.
    5) instead of spraying Rem-oil into the gun, right from the can, I spray it on Q-tips and apply to only the areas I want to lube. Namely, the slide.

    At first, I was spraying the gun like a maniac, then I realized that it was better if I selectively cleaned the gun- that way the gun wouldn't be dripping oil and grease all over my clothes.

    if you take nothing away from this, just remember... Q-Tips
  11. hexidismal

    hexidismal Well-Known Member

    Nice gun, I'm jealous ! :fire: Tell me though, did the salesman worry at all when you were jumping up and down in the store screaming "Ive got a gun !! I've got a gun !! i can't believe they gave me gun !!!" .. hehehe
  12. harvester of sorrow

    harvester of sorrow Well-Known Member

    In my experience working with at least a thousand Berettas, they don't mind being dirty, but they absolutely HATE being dry. Easily one of the most forgiving handguns around as far as limp-wristing is concerned. When you can feel the slide dragging and it starts to sound like the spring on a screen door when it cycles, you need to lubricate it.
  13. Talk about a nice gun for a first firearm. My first was a crappy lil' .22mag revolver.
  14. ceetee

    ceetee Well-Known Member

    What's the deal with the cover over the accessory rail?
  15. Zen21Tao

    Zen21Tao Well-Known Member

    Congradulations on your first gun and your relocation from NYC.
  16. hankdatank1362

    hankdatank1362 Well-Known Member

    Please don't go running aroung in the real world screaming "I have a gun! I have a gun!" with a big grin plastered on your face.

    People might take it the wrong way.:p
  17. CountGlockula

    CountGlockula Well-Known Member

    Good one hankdatank1362!
  18. Abby

    Abby Well-Known Member

    Congrats, Polack. I've gotten a (good) kick out of following your migration. Glad you made it down here - I hate this state, but it IS great for gun ownership.

    Enjoy your new baby. :D
  19. iiibdsiil

    iiibdsiil Well-Known Member

    You know about floridashootersnetwork.com yet?
  20. Arkie

    Arkie Well-Known Member

    Congrats on a Really nice looking Pistol. :)

    Sounds like you are going to have a lot of fun with it too.

    Enjoy your New Found Freedom!!! :D

Share This Page