I've carefully finished my first batch of 9mm for my HP 995TS Carbine. The case width has a barely noticeable 4 thousandths indentation in the overall taper from the mouth to the rim. The indentation is just after the area where the bullet seats. The OAL is fine. I set the FCD to only crimp enough to hold the bullet firmly. As you can see from the pic and dimensions, there's an ever so slight indentation in the case just below where the bullet seated inside the case. None of my factory rounds have this 'feature'
They chamber fine. Is there any problem in using these rounds? What can I do differently to eliminate the hump?
They chamber fine. Is there any problem in using these rounds? What can I do differently to eliminate the hump?