guyfromohio
Member
I have both the desire and the green light from the finance department to purchase reloading equipment. With 9mm and .223 being my primary ammo, I know the cost/savings ratio isn't in my favor... but that's not necessarily my drive.
I have never reloaded. Never even seen it done. That being said, I'm looking at the Dillon xl650 based on recommendations from friends with some experience. Not considering the cost versus cost of SIMILAR systems, does it make sense to go right to that type of sophistication? Am I missing a necessary learning curve of a single stage? Not looking to tune precision loads, but more to "manufacture" in bulk for my own use. Thoughts?
I have never reloaded. Never even seen it done. That being said, I'm looking at the Dillon xl650 based on recommendations from friends with some experience. Not considering the cost versus cost of SIMILAR systems, does it make sense to go right to that type of sophistication? Am I missing a necessary learning curve of a single stage? Not looking to tune precision loads, but more to "manufacture" in bulk for my own use. Thoughts?