Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
I know this is probably stupid question...but does the Hornaday lock-n-load conversion work with Lee dies since they use an "O" ring? Or should I go with different dies?
Honestly, I don't see the big deal about the Lock-n-Load system unless you're using the progressive press. On the progressive it saves a lot of time because you're swapping a lot of dies in and out for different calibers and stuff. On a single stage, threading dies in and out didn't seem like a big deal to me. I used good lock rings on the dies so I didn't have to set them up again every time I used them, and that was that.
Since I have the Lock-n-Load AP progressive press and all my dies are in the LnL bushings now, it would be ideal for me to also have the LnL setup for my single stage press. If I didn't have the LnL AP, I'd just stick with the standard threads.
You can use Lee dies with lee lock rings if you turn the lock rings upside down.
I have an LnL AP and a Lee Classic Cast with a LNL converter bushing installed. I have the Classic Cast converter shimmed so that I get the same OAL on both the single stage and the LnL AP.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.