savagelover
Member
- Joined
- Feb 7, 2012
- Messages
- 592
My 6BR is acting up.
With a starting load from the berger manual using
H322 with the 68 grain bullets,I am getting a stiff
bolt lift..And the cases will not rechamber..
I am full length resizing as well..I seems to do it
with other powders as well..I put the barrel on myself
as I have done with a few others,and never had any
issues..
Will too much head space cause this ??? I suppose it
is possible the nut did not get locked down tight enough.
If it is head space problem..My other barrel was ok..except
I wore it out..I just sent into the place to rent the
go and no go gauges..All brass (lapua) has been trimmer
and like I said..Full length sized.They chamber with
ease..But as mentioned,after fireing,will not rechamber..
Thanks for any advice...
With a starting load from the berger manual using
H322 with the 68 grain bullets,I am getting a stiff
bolt lift..And the cases will not rechamber..
I am full length resizing as well..I seems to do it
with other powders as well..I put the barrel on myself
as I have done with a few others,and never had any
issues..
Will too much head space cause this ??? I suppose it
is possible the nut did not get locked down tight enough.
If it is head space problem..My other barrel was ok..except
I wore it out..I just sent into the place to rent the
go and no go gauges..All brass (lapua) has been trimmer
and like I said..Full length sized.They chamber with
ease..But as mentioned,after fireing,will not rechamber..
Thanks for any advice...