guys i am closing in on done on my lemat carbine took the trigger guard off to make into a carbine trigger guard and a spring poppped out ?? how does it go back in ?? thanks
It Keeps tension on the trigger so that it will engauge the notches on the hammer. It is best to start both screws and tighten them down evenly when reassembling the trigger guard other wise if the guard becomes canted stripped threds could result = big PIA
i had put it in upside down cocked and then cocntacted you , noew i flip it and cock it and now the hammer doesnt sit tight against the cylinder ^%#&(^%)*^!!
whats wrong now??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.