This is my first time posting, if this isn’t appropriate for this board please let me know. SO About a year and a half ago I picked up a cobray m-11 it looked like it would be a blast to shoot. It was made during the ban so it came with only a 10 round clip. I put it in my safe thinking the next time I order online I would get a 30 rounder for it. Well I put it off until finally a few months ago when I was at a gun show and I saw a m-11 clip with the cobray stamp. It was one of the zytel clips. I paid $30 for it and it went into my safe with the mac 11 . So then finally yesterday I was going to the range for the first time in along time and I got out my mac, I loaded the 10 round clip with 115 gr Winchesters and was pleased with the results (crappy grouping but FUN) then using the same ammo I loaded the 30 round clip It chambered the first round but then immediately jammed. So I jacked that round out and the bolt closed, I fired it again and it jammed. That’s when I realized that there was some give with the clip, so I tried holding the clip and pushing it into the receiver with one hand and shooting with my other. the reaming 26 rounds fired fine, as long as I pushed the clip into the receiver. I also tried setting it on a table and firing this worked fine as well. My question is, do you think it’s the clip or is it the gun?
my mac 11 problem
- Thread starter davieboy
- Start date
- Status
Justin
Moderator Emeritus
It's the magazine.
The notch in the magazine that the inside of the gun engages is cut incorrectly. Get rid of that magazine and order a new one.
The notch in the magazine that the inside of the gun engages is cut incorrectly. Get rid of that magazine and order a new one.
Banaka9999
Member
- Joined
- Jan 26, 2006
- Messages
- 3
Is it possible to personally perform a modification to the magazine so it works and loads properly?
- Status
