Noticed that too, but I think that's just how they make them now. I checked all the new Taurus in 3 stores before I bought mine, and they were all that way.I see the cylinder is loose right out of the box.
In a 1911 that type of tolerance might be acceptable, but in a revolver I call it poor quality. I have a 50 year old S&W J frame that is tighter than the Taurus featured in the video!Noticed that too, but I think that's just how they make them now. I checked all the new Taurus in 3 stores before I bought mine, and they were all that way.
Only if there's a choking hazard.Jeez, do you guys take toys away from babies too?
So you are on record as saying that Taurus Revolvers are of the same quality as the average 1911? As a Taurus owner it is refreshing to see some positive comments on Taurus instead of the usual bashingIn a 1911 that type of tolerance might be acceptable, but in a revolver I call it poor quality. I have a 50 year old S&W J frame that is tighter than the Taurus featured in the video!
LD
You really need to cock it and see how tight it is. That said, I don't have any revolvers that are that loose prior to being cocked, but I have some that are close. One Rossi 88 I own is somewhat loose, but when you cock it it's tight as a vault. I doubt that Taurus is tight, cocked or not.I see the cylinder is loose right out of the box.
So you are on record as saying that Taurus Revolvers are of the same quality as the average 1911? As a Taurus owner it is refreshing to see some positive comments on Taurus instead of the usual bashing
No, you need to drop the hammer and keep the trigger to its rearmost position and then check for play.You really need to cock it and see how tight it is..
As you wish.No, you need to drop the hammer and keep the trigger to its rearmost position and then check for play.
Jeez, do you guys take toys away from babies too? Let the man enjoy his new acquistion. It was/is important enough to him that he wanted share.
Lighten up a bit.
SteveThanks for the replies, everyone.
I'm not sure about the loose cylinder, but I willl make a range report video later.