wickedsprint
Member
Just recently acquired a 6.5" stainless Single Six in 17HMR and noticed gap appeared a bit wide so I decided to measure it.
Cylinder to the rear, hammer down .009, .010 No go
Cylinder forward, Hammer down .008, .009 No go
This seems to be on the high side, thoughts?
For comparison, my GF's SP101 .357 is: .002-.005
Cylinder to the rear, hammer down .009, .010 No go
Cylinder forward, Hammer down .008, .009 No go
This seems to be on the high side, thoughts?
For comparison, my GF's SP101 .357 is: .002-.005
Last edited:
