1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Parts for a Texan Single-Stage Press

Discussion in 'Handloading and Reloading' started by Spot, May 18, 2009.

  1. Spot

    Spot Active Member

    I acquired a Texan Single-Stage Press about a year ago, and am wondering on just how interchangeable it is to other single-stage presses. This one is a "C" type. The toggle pin is missing.

    As the local pawn shop is charging $30/box of 8mm Mauser 170 gr, I'm going back to reloading.
  2. Sunray

    Sunray Well-Known Member

    You won't find Texan parts, but you can measure the hole and put in a suitably sized bolt and nut with a washer(easiest fix) or a piece of bar stock. Likely about 3/8", but I'm guessing. As long as it uses 7/8-14 dies, you're all set.

Share This Page