ferggie
Member
Set up to load 45 ACP 200gr LSWC, OAL 1.25 using WST. Digital scale warmed up for about 30 min. Calibrated it and proceeded to adjust LNL powder measure to drop 4.6 gn's. Everything seemed fine and started loading. Checked the load after 50 rounds and the scale was acting strange. pulled out the balance scale and found it was dropping 5.2 gn;s. Pulled a couple of bullets and in fact they were 5.2gn's.
The max load listed for WST with this bullet is 5.1 gn, granted that is with an OAL of 1.225. I am afraid these will be to hot and need to pull them.
Any suggestions on the best way to pull a bunch of 200gr LSWC's?
The max load listed for WST with this bullet is 5.1 gn, granted that is with an OAL of 1.225. I am afraid these will be to hot and need to pull them.
Any suggestions on the best way to pull a bunch of 200gr LSWC's?