DontBurnMyFlag
Member
Hey everyone. I have a S&W Model 10-7 and I've been having a bit of a problem. All the shells fit into the cylinder fine, that is until they have been fired. There is this one slot in which the shell sticks. It takes alot of force to take it out, and its really a pain in the neck.
So I took some Hoppes 9 and a tornado brush and cleaned out that slot really really well. I made sure the carbon was all gone and the slot was well greased and shiny. However, when I took it to the range today, I still had the same problem.
Any suggestions or advice?
So I took some Hoppes 9 and a tornado brush and cleaned out that slot really really well. I made sure the carbon was all gone and the slot was well greased and shiny. However, when I took it to the range today, I still had the same problem.
Any suggestions or advice?