Southernsorrow
Member
I've been using wipe-out: patch-out for years and only have a few drops left. "had 3 of the 8oz bottles"
My routine usually goes:
1. carbon cutter
2. general cleaner to get harder stuff out "this is what I need more of"
3. bore brush then patch with general cleaner
3-a. stubborn copper removal if needed
4. coat bore
5. Lube, or grease if needed
6. Rust protection
Looking at buying either more Patch-out or if these are any better get Froglube or mpro-7..
any try/use any of these to be able to gimme a comparison on which works/worked better? best all around cleaner for general carbon,lead,copper.. I basically went from hoppes #9 to hoppes elite back in early 2000s to patch-out and haven't really tried any others "tried bore tech eliminator awhile back" don't remember if it was any good though :-x.. before anyone suggest have/tried break-free clp and doesn't clean too good vs patch-out
I already have:
lube "slip-2000EWL and gun butter"
Grease "Gun Butter grease ,and tetra"
Protection "Eezox"
Stubborn/heavy copper "KG-12 big bore"
Stubborn/heavy lead "Remington bore scrubber" the stuff with grit in it.
If it matters guns to clean, P229 , P226 ,2 Ar-15 , 2 savage .308s "benchrest and hunting" , Taurus raging bull , Sig Mosquito , 2 mossberg shotguns , several 10/22s and some others.
My routine usually goes:
1. carbon cutter
2. general cleaner to get harder stuff out "this is what I need more of"
3. bore brush then patch with general cleaner
3-a. stubborn copper removal if needed
4. coat bore
5. Lube, or grease if needed
6. Rust protection
Looking at buying either more Patch-out or if these are any better get Froglube or mpro-7..
any try/use any of these to be able to gimme a comparison on which works/worked better? best all around cleaner for general carbon,lead,copper.. I basically went from hoppes #9 to hoppes elite back in early 2000s to patch-out and haven't really tried any others "tried bore tech eliminator awhile back" don't remember if it was any good though :-x.. before anyone suggest have/tried break-free clp and doesn't clean too good vs patch-out
I already have:
lube "slip-2000EWL and gun butter"
Grease "Gun Butter grease ,and tetra"
Protection "Eezox"
Stubborn/heavy copper "KG-12 big bore"
Stubborn/heavy lead "Remington bore scrubber" the stuff with grit in it.
If it matters guns to clean, P229 , P226 ,2 Ar-15 , 2 savage .308s "benchrest and hunting" , Taurus raging bull , Sig Mosquito , 2 mossberg shotguns , several 10/22s and some others.
Last edited: