Southernsorrow
Member
I was given about 500 .40cal 180gr HST reloads "rmr sells pulled from time to time" the problem is my buddy factory crimped them with a lee die and my sig with barsto doesn't feed smoothly with anything lee factory crimped...
I always use a Taper crimp rcbs and it will then shoot/feed anything I throw at it. The ammo shoots fine and accurate just always feel a clunk when cycling the next round as if the case rim is catching, which I do not get when using my own reloads with the taper. It hasn't fully jammed yet but it tries to when cycling in a new.
Is there a way to lightly taper crimp them, since it basically is just knocking down the rim ?
I always use a Taper crimp rcbs and it will then shoot/feed anything I throw at it. The ammo shoots fine and accurate just always feel a clunk when cycling the next round as if the case rim is catching, which I do not get when using my own reloads with the taper. It hasn't fully jammed yet but it tries to when cycling in a new.
Is there a way to lightly taper crimp them, since it basically is just knocking down the rim ?