roval
Member
this is an update on my LB 1911 heavyweight monolith.
it had failures to eject. i had sent it back to Les Baer and while there, had them hard chrome it. I've taken it to the range for 200 or so rounds before and now again for another 150 rds and so far no hiccups with 230 rn and 200 gr swcs. full and moderate loads.
i also wanted to see if the flgr i installed will cause any issues(it will make reassembling the gun easier... i had dinged the end of the dustcover in the process before. no problems.
also found my 200 gr swc sns powder coated with 5 gr bullseye was a good enough load for me.
this was my best 25 yrd target offhand either 4 or 5 mags , 32 or 40 rds. 200 gr swcs. there was one round that didn't make it onto the paper.
it had failures to eject. i had sent it back to Les Baer and while there, had them hard chrome it. I've taken it to the range for 200 or so rounds before and now again for another 150 rds and so far no hiccups with 230 rn and 200 gr swcs. full and moderate loads.
i also wanted to see if the flgr i installed will cause any issues(it will make reassembling the gun easier... i had dinged the end of the dustcover in the process before. no problems.
also found my 200 gr swc sns powder coated with 5 gr bullseye was a good enough load for me.
this was my best 25 yrd target offhand either 4 or 5 mags , 32 or 40 rds. 200 gr swcs. there was one round that didn't make it onto the paper.