I cleaned the dies on my LEE turret press and changed the disk on the LEE auto disk powder measure because i switched from N110 to 3N37.
With the disk set to .66 it should throw 7.2 grains bit it dropped only about 6.4. I did not just switch to the next larger disk because of:
This is the disk in the "loading" position:
Fine, everything is OK
This is the position where it should drop the powder:
This doesnt look right.
What is my mistake?
With the disk set to .66 it should throw 7.2 grains bit it dropped only about 6.4. I did not just switch to the next larger disk because of:
This is the disk in the "loading" position:
Fine, everything is OK
This is the position where it should drop the powder:
This doesnt look right.
What is my mistake?