I have never seen this discussed. Of course it should be done in a well supported (supportable) area of the AR lower receiver. Any mechanical reason this would not work?
Intresting idea but I think that's a bit silly to do having a metal stamp cut to ID your SBR unless you're doing 10+ and even then wouldn't it just be cheaper to have someone engrave em for you?
Intresting idea but I think that's a bit silly to do having a metal stamp cut to ID your SBR unless you're doing 10+ and even then wouldn't it just be cheaper to have someone engrave em for you?
and some practice would be much better on the mechanical of any metal.
Used to ID mold parts in a mold shop with one for years. For very hard steels we would get a cheap diamond burr.
Make sure you practice, because the thing can "take off" in an unwanted direction.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.