ferggie
Member
After tumbling the brass (corn cob / walnut) I end up with nice shiny brass but have a power residue on it. Do you wipe, wash or just load it at that point? Will it cause any issues?
After tumbling the brass (corn cob / walnut) I end up with nice shiny brass but have a power residue on it. Do you wipe, wash or just load it at that point? Will it cause any issues?
Do as walkalong sayes. Then tumble and reload.
We're not into rocket science here.
I am concerned about the build up as well (IDPA also). Should I deprime tumble them ultra sonic the brass to remove the residue from the CC and walnut media?
After tumbling the brass (corn cob / walnut) I end up with nice shiny brass but have a powDer residue on it. Do you wipe, wash or just load it at that point? Will it cause any issues?
JCwit, you may be right for the most part. But I don't use any polish and I would still get a pretty good amount of dust?
I have thought about converting to SS media, but would have trouble being patient waiting for cases to dry.