6pak
Member
I broke open my new Lee Collet 30-30 die set last night and sat down to do some reloading. After going over the directions (Lee Precision could use an upgrade to their tech writing staff by the way) I proceeded to re-size 20 cases trimmed to a length of 2.029. When I went to seat the Hornady 150 grain bullet and raise the ram the slug would slide nearly all the way into the cartridge case. I was actually able to seat and crimp only just six out of twenty. Whats' up with this? Did I just over-stretch my case mouth? Can I empty the cartidges, run them through a full length sizer and start from scratch? Any thoughts from more experienced re-loaders would be appreciated.