Recent content by Beochie

Thanks for the help. I have a dillon case guage comming to make sure my cases are in spec. I'll also have to check my neck tension to make sure it is enough to do the job.

I'll give that a shot and see how it does. My only conxern is that everything I have read says a crimp mandatory with a mag. fed gun.

I sized and then trimmed to 1.742. why would you trim a case and then re-size it? seems like that would distort the work you just did. Steve, thats not what I got out of the rcbs directions. If you back the die OUT from where it touches the case, how will it make a crimp? Thanks for...

Im using rcbs x dies. I am not putting the mandel down far enough to where the x die feature is touching. For crimp im fl sizing a round. 1. Backing out the second die so that the crimp action is not working. 2.adjusting my seating rod down untill I have a bullet seated in the case of an...

I just started reloading and have shot about 50 of my reloads without a problem. Well I was out today shooting my LC 09, 22 gr h335, 62 gr nosler balistic tip, cci 400 primed loads. 20 or so shot fine, but on the last round of a mags the gun didn't lock the carrier back( I thought this was...

gotcha 18"brl. I was just trying to find a good fragile one that can take the RPM

I'm looking for a target/varmit bullet that can be pushed 2900fps+ out of a 1:7 223/5.56 barrel. stay intact in flight but still blow up once it hits something. affordable would be nice too.