Recent content by dmproske

I had tried one of these for my wife. Would not run unless it was literally dripping with oil. Junk.

? That mesa brand is certainly no better than a sentry. Sent from my HTC6435LVW using Tapatalk 2

Call Springfield. I bet they will send you one at no cost.

Yup. Try calling Cannon. You never know. Then you are going to have to call a locksmith. Have them put on a S&G commercial grade dial lock. This is the classic reason we constantly tell people to get a quality dial lock insted of a electronic one. Yes the keypad is a lil faster, but as you know...

Lol on that part. But yes that does happen. They will come out with a roll back wrecker and winch your bolted down safe out of the concrete floor and right onto the back of the truck and drive off before an officer is even dispatched. That's when its in the garage. If in an interior room, and...

I have an ax, sledge, and a couple pry bars where my safe is going. I will put them in the back corner of the safe. I am also going with a big Sturdy safe 48x27x72. I am going with the fire liner. I have a small Sentry firebox with my docs in it that will go on one of the shelves.

Do you think it is worth my money to get the extra 3/16th stainless steel on the sides of the safe? That option is 600. It would make the sides of the safe 3/8th thick and resistant to torch and hammer/ax attack in the common areas thieves target. they can also add regular 3/16th sheets there...

For me, I wouldn't trust my guns to a 1/8" inch walled safe. A sledge hammer, ax or espically a fire ax will make quick work of it. Probably has unsupported door bolts. Easy to pry open. Look at the videos on you tube. Very telling.

Thanks fellas ill call 10 ring tomorrow.

Yeah Carters didnt carry it. At least the one on the katy fwy didnt. Have not checked with Collecters yet.

Anyone know of a place selling Ramshot powders in Houston? I would like to try a pound of TAC and Magnum without paying a HAZMAT fee for ordering just two pounds of powder.

There seems to be some confusion on the net regarding the X mark pro trigger. On the newer rifles you do not need to remove the action from the stock, heat screws, break glue loose ect... I just got a 2009 model M700 with the user adjustable X-Mark Pro trigger. On these the adjustment screw...

Since CCI and Federal are part of the same company, does CCI make Federals primers? I heard one one board that CCI expanded their primer production. Another board posted that CCI had equipment failure in the production line and was having problems making repairs. Can anyone confirm either...

I was at the location in Spring and Katy fwy today. Trucks came in this morning. They both had 1lb cans of Varget. The Katy fwy store said they got a couple cases in. The katy fwy store also had a "limited" supply of Remington large rifle primers. I finally got my Varget without being robbed...

http://www.unclebudsbullsbags.com/