Recent content by eagle24

  1. E

    Identity and Date of Manufacture of S&W Revolvers

    Model 657-5 (stainless) .41 mag 7-1/2" barrel adjustable sights - black rear / orange ramp front smooth target trigger target hammer Hogue Grip (from factory) serial # CJR5XXX TIA, Greg
  2. E

    1885 Winchester Sights

    What is the "turn down" aperture?
  3. E

    1885 Winchester Sights

    I have a 1885 low wall chambered in 25-20 single shot. I believe the tang sight that is on it is a Lyman #1. It is not threaded for eye cups and has a fairly large hole. I don't feel like I'm getting the consistency I would like with the sight alignment (although I'm shooting pretty good...
  4. E

    .25-20 single shot

    No, but thanks. I may end up trying some heavier bullets, but I'm wanting something about 85 gr to start with since I know it shoots them well in the factory loads.
  5. E

    .25-20 single shot

    .25-20 Single Shot cartridge NOT .25-20 WCF. I'll load smokeless (always) starting with IMR 4227. I know about the lube. I really don't want to shoot jacketed bullets. All indications are that it shoots well with a lead .257 dia 86 gr bullet at around 1200 fps. Pretty sure the rifle has...
  6. E

    .25-20 single shot

    The rifle is a 1885 Winchester, but it is chambered for .25-20 Single Shot. It is NOT .25-20 WCF. I have shot it with some original .25-20 Single Shot cartridges and It shot well. Nickel sized group at 25 yards. I pulled the bullet on a couple of cartridges and weighed them at 86 gr. They...
  7. E

    .25-20 single shot

    Recently traded for a 1885 Winchester Low Wall in .25-20 single shot. I have aquired plenty of brass, but I'm having trouble finding any bullets, or the right mold. Anybody know where to find .257 dia 85-87 gr bullets or a mold?
  8. E

    9mm handgun or 22 rifle?

    Ruger 10/22 rifle without question imo!
  9. E

    What finish is on Rem. 870?

    Just my opinion, but I would never leave any gun in the trunk of the car for the winter unless I was wanting a rust finish.
  10. E

    Lightweight 20 ga shotguns

    Thanks for the replies. The Benelli doesn't appeal to me. I just don't care for the less traditional look. Length, weight, sling swivels on the Mossberg are all a plus. I may try and find one I can put my hands on and see in person. My preference is still for the Ithaca if I could find a...
  11. E

    Lightweight 20 ga shotguns

    I'm looking for a lightweight 20 ga shotgun for squirrel hunting with dogs. I usually carry a .22, but at times a young dog needs the squirrels knocked out to it, and I need to carry a shotgun. Especially late season when the squirrels seem to timber out more often. What would be good choices...
  12. E

    Custom Squirrel Rifle

    Thanks for all the replies and input! Here's what I've decided on: Ruger receiver Tac-Sol fluted x-ring barrel (threaded w/muzzle brake) Trigger Job for a nice 4lb trigger 1" charging lever Extended Mag Release Hogue OM (black) picatinny rail Leupold 2-7 x 28mm VX-1 Leupold rings...
  13. E

    Custom Squirrel Rifle

    Budget: Like to stay under $600 without optics Trigger: Slick, crisp, but not under 4 lbs. I may hand this rifle off to a youngster to shoot out a squirrel or coon from time to time. This build is about having fun with squirrel and coon dogs and lightweight. I don't need an absolute...
  14. E

    Custom Squirrel Rifle

    Yep. I agree with the downside to lightweight, but 98% of the time I am carrying. I can find a good rest most times and just want to knock them out to the dogs. Carry = 99% for me. I want light weight most and by far.
  15. E

    Custom Squirrel Rifle

    Guys, I appreciate the replies. I know what is needed to hunt squirrels. Have several .22's that will do the task. I just have a hankering to build a light weight, short custom 10/22. My hunting is mostly about the dogs and sometimes carrying ANY rifle is my least favorite part of it. If I...
Back
Top