Never thought to go on GB to look. From what I see there I got some 150 GR M61 AP bullets. Question is do I waste the time to work up a load for them or dump them and buy some regular.
I did cut it open and I has a magnetic steel core that is very hard. I read that AP used a tungsten core.... or maybe it was an old news real... in the M1 AP round. I thought tungsten was non-magnetic.
I managed to find some bullets to reload but found out they are old AP rounds. Took on apart because it looked way too long to only weigh 152 GR. Did weigh several and they are very inconsistent 152 down to 147. The bullets also have 2 cannelures. What would be a starting place for a charge...
I have a DPMS pattern lower and an aftermarket upper. Everything went together fine but when I chamber a round it does not extract . Trying to hand mount a round on the bolt face is extremely difficult. Have not shot it. I think the extractor is not grooved wide enough for the base of the...
I have a G19 GEN 3 I think...Was a poly 80 build in 9MM. I was told by a dealer that the frame is the same on a 19 and a 22. The internal parts are different along with the slide and of course the barrel. That being said I was pondering a 40 /357 sig build on a 19 frame. Is that possible...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.