-
-
HEAVY METAL 1 replied to the thread What's up with this .357 sizing die?.Have you tried your brass in it recently? I wonder if it affects it at all. -
HEAVY METAL 1 replied to the thread Powder prices going where now?."My guess is that your local retailer had a relatively large stock of H335 priced at the old price point, and has only now replaced...
-
My favorite local retailer just raised the price of H335 by $10.00 to the sum of $51.99 a lb. That's a jump of over 21%. What the...
-
Five is too many, unless you just want them. (I only really "need" two fly rods, but that hasn't stopped me from owning...more than...
-
Welcome! To be honest, I think 5 guns are superfluous. If all you want them for is hunting, a .22 for small game and a 30-06 for...
-
HEAVY METAL 1 reacted to dh1633pm's post in the thread Does AI (Grok) give good hunting and shooting advice? with
Like.
AI is great. Use it all the time for all sorts of things. Lex (mine called itself Lex) what size wrench do I need to remove the blades... -
HEAVY METAL 1 replied to the thread Can I save my dad's rusty dies?.If careful one can find slightly rusty, but serviceable seating dies at gun shows and clean them up. Then you can have extra dies per...
-
Mine last years but I don't go for squeaky clean. Since 99% of my shooting is with lubricated cast bullets I don't have copper fouling...
-
HEAVY METAL 1 replied to the thread Screws loosening.I put the gun through its paces today and the screws held. All is joy in revolver land.
-
HEAVY METAL 1 replied to the thread Screws loosening.I degreased the holes and screws themselves with alcohol and dried them. I applied the Loctite 242 with a pointed toothpick. I am...
-
HEAVY METAL 1 replied to the thread Well I really did it this time....Get a brass rod from a welding supply shop. Drop it down the barrel and tap the rod with a hammer. Gun forums are full of horror...
-
HEAVY METAL 1 reacted to Howa 9700's post in the thread What does everyone use for measuring powder with Like.
When doing load development, Lee dippers and then trickle up on a balance beam scale. Once load development is over, the charge is...
-
HEAVY METAL 1 replied to the thread Screws loosening.In my area the Loctite will be easiest to source and since so many here have endorsed it I am not fearing using the blue product. Thank...
-
I have two sideplate screws on my 357 revolver that keep loosening even after having been snugged down. In fact what alerted me to the...
-
HEAVY METAL 1 reacted to twofewscrews's post in the thread How do you load up your gear for a range trip when you live in an apartment complex? with Like.
I pull into at least one gas station and sit for a minute . . . I've never had anyone follow me in and out, but if I do the next stop...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…