So I FL sized my once fired 204 cases. The OAL of cases varies but not to the point of being over length. Sould I trim all to same length or just load them.
How will this effect accuracy. Thanks
New reloader here. This has probably been asked before but here goes.
I shoot bolt action rifles. the brass I am reloading has been shot in my rifle.
so, do I full length resize or neck size. I'm not using bushing dies, seems a little to complicated at this point.
New reloader here. I bought some Nosler 204 Ruger brass. Says its fully prepped and ready to load. Measured case length and calipers are reading 1.829. Reloading book says case lenght should be 1.840. How will this effect
COL and seating depth. Also should I full length resize this brass before...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.