Recent content by jkupp20000

Thanks that helped I'm going to call Lee tomorrow and see if they will send me a new cutter. I tried to clean the threads and reinstall the sizer but it still will not sit flush.

Hey guys not to steal this thread but does anyone know if this is seated right. I tryed this one and another one but the both stop at the same place. Any help would be great.

Hi all I put this bench together with scrap wood and a $13.00 peice of plywood for the top.

jmr40 I just got the Lee and the lenght gauge does not seem to sit flush with the cutter part. Does your sit flush or is it raised for a reason? Thanks

I did not take it apart but I did soak it for a day and then I moved it forward and backward untill all the grease came out. Then I took some solvent and soaked that into it and worked the pin untill all of the solvent came out. Thanks

I called classicarms today and they are sending me abox to ship it back to them for repair.:)

I did clean it after watching a few youtube videos. Is there a way check the sear on most guns?

Hey guys I just bought a Yugo M57 and when I got to the range I put about 30 round throught it and then I pulled the trigger and two rounds where fired. I tried it again and the same thing happened. Then I tried it one more time and it was back to a one pull one round gun. I took the gun home...