-
-
jmorris reacted to Walkalong's post in the thread What does everyone use for measuring powder with
Like.
I used to use a Hornady pistol measure that I rigged to work automatically on my Projector. Then I finally "upgraded" to a Redding 10X... -
jmorris reacted to d31tc's post in the thread What does everyone use for measuring powder with Like.
For my rifle loads, I use one of my RCBS Uniflow powder measures and trickle up on a Lyman M5 with a vibratory trickler and optical...
-
jmorris replied to the thread es/sd standards.Distance, speed leading to the resulting trajectory and expectations. Sometimes it can matter a lot even up close. You can watch the...
-
-
jmorris replied to the thread Chronograph the garmin.It's more than just and on/off switch but its not a Rubik's cube. 4 buttons Ok, back (hold for on off), up and down. Press and hold...
-
-
jmorris replied to the thread Hunting with a 223/556 11.5 AR.I'd probably use a 450 bm or 458 socom for deer don't need thhat much energy for the job but I have never killed one too dead. The 110...
-
-
jmorris replied to the thread Well I really did it this time....Yeah, I'd likely would have started with an enlarged flash hole case and magnum primer first.
-
jmorris replied to the thread Well I really did it this time....That probably would have been a better option when the bullet was partially sticking out of the barrel.
-
jmorris replied to the thread What does everyone use for measuring powder.Depends on the powder. Many will meter out of measures within a tenth. A photoelectric switch to detect beam movement, running a tiny...
-
jmorris reacted to Chuck R.'s post in the thread Gun Vise That’s Sturdy Enough For Muzzle Device Torqueing? with Like.
How sturdy of a folding table?? A setup like this might work: You could use a kitchen counter, provided your wife isn't home..
-
jmorris replied to the thread Gun Vise That’s Sturdy Enough For Muzzle Device Torqueing?.If I don't have anything to put a holding device on to help actually hold something, I find something that isn't likely to move with the...
-
-
jmorris replied to the thread XL650 issue.If the shell plate bolt is tight, that is your problem. The SD is the only Dillon press where you run it down until it stops. If it...
-
-
The YH is a common PCP compressor. Most seem to have decent luck if use scuba compressor oil (Seco 500) and change regularly and limit...
-
They do work quite well, but get a better water separator for it. The one that comes with it is not nearly enough...
-
jmorris reacted to Chuck R.'s post in the thread FFP vs. SFP for practical use—do you actually care, or is this more of a range flex than a field necessity? with Like.
I have and use both. Anything that will be used for precision, and/or distance gets a FFP scope, it's just easier to use. I also like...
-
jmorris replied to the thread How do you load up your gear for a range trip when you live in an apartment complex?.Disguising firearms made me think of this exchange, still makes me laugh.
-
-
-
Loading…
-
Loading…
-
Loading…
