-
-
J frames will never go away. -
The malfunction drill kind of goes against what most would consider normal handling and may seem a bit strange the first time you do it...
-
I already mentioned this, but my EDC was a Shield 45. Had it about 7 years now (2017). Never had even one issue. Had it to the range...
-
I own two. A 642 I carried for 30 years as a back up at work. Too sentimental, can’t get rid of it. And a 650. 3”. .22 Magnum with a...
-
Well started on the job in 1981. Carried a 4 model 15 with a 36 as backup/off duty.Spent 33 years on the job, carried several different...
-
You're right. Not rational. Maybe fun. Fun to own, but to shoot? 50 cal, 300 to 460 grain at 35,000 PSI. NO, THANK YOU.
-
When I saw the title of the thread I misinterpreted it. I thought you were asking if one Bond derringer was enough. I thought it was a...
-
jstert reacted to BobWright's post in the thread Single action 357mag or 45LC in short'ish barrel? with
Like.
Well, for whater its worth, here are my thoughts: For a Single Action revolver, I see no advantage going under 4 3'4" ~ 4 5/8" barrel... -
jstert reacted to Pat Riot's post in the thread Single action 357mag or 45LC in short'ish barrel? with Like.
I was going to recommend that since you already have guns in .45 ACP that you look at a Ruger convertible in .45 ACP / .45 Colt or buy a...
-
jstert reacted to gnappi's post in the thread Single action 357mag or 45LC in short'ish barrel? with Like.
I have two SA 3 3/4" barreled "gator" guns that I carry fishing. A .45 Colt Ruger Vaquero and a Ruger Super Blackhawk in .44 mag. and...
-
jstert reacted to doubleh's post in the thread Single action 357mag or 45LC in short'ish barrel? with Like.
I can shoot a shot barreled 357 loaded to 38 special loads for many shots especially when it's used in a Blackhawk. Load the short...
-
jstert reacted to Varminterror's post in the thread Single action 357mag or 45LC in short'ish barrel? with Like.
My personal pursuit in this landed on an ejectorless 2 1/2" Convertible New Vaquero in 45 colt/ACP and a brace of Vaqueros in 44mag I...
-
jstert reacted to sevt_chevelle's post in the thread Your recommendation for best DA/SA inexpensive for EDC with Like.
Problem with that is finding good magazines. CZ doesn't make the mags any more, and current crop of mags marked CZ are aftermarket junk.
-
jstert reacted to sgt127's post in the thread Your recommendation for best DA/SA inexpensive for EDC with Like.
Be careful with the retro guns. Magazines for some of them are getting ridiculously expensive. Solid reason to go for Retro revolvers!
-
One thing to be aware of regarding side-by-sides is that with the typical internal hammer guns, you'll need to either store them...
-
-
Loading…
-
Loading…
-
Loading…