K
Kp321
Latest activity Postings Images About
-
-
KKp321 replied to the thread Lubricant for carbide dies?.In my 60+ years of reloading I have tried most of the lubes, both commercial and home made. IMO, there is nothing better than the waxes...
-
KKp321 replied to the thread Keeping reloads in like new condition.Fitz and Brasso were both mentioned in responses. These polishes should be avoided on cartridge brass because they contain ammonia which...
-
KKp321 replied to the thread Scope Base Screw Stripped.For stripped Allens I normally use method 3, but only with a drill press or mill. Be sure to verify the screw size and use the proper...
-
KKp321 replied to the thread Cheapest, easiest way to trim a lot of .223 brass?.I’m surprised no one has mentioned it, the Lee case trimmer is the cheapest out there, especially for one caliber. Total investment...
-
KGunsmith is Latin for "not an armorer".
-
KKp321 replied to the thread Sweet spot for .22LR rifle value?.CZ 457 is probably the best value out there. Not cheap but a very smooth accurate rifle for the money.
-
KKp321 replied to the thread REMOVE A BRAZED IN FLASH HIDER.What’s going to happen when you get the flash hider off? Will you instantly have an illegal SBR? Most pinned flash hiders are...
-
KKp321 reacted to Blue68f100's post in the thread Removing rusted screw with buggered head. Got it out; update p.3 post #70 with
Like.
No Disk cutter, you want have room on the sides. HF has a complete set of diamond bits, that has some small cylinder shapes that will... -
KKp321 replied to the thread Proper Firing Pin Protrusion?.The OP asked specifically about a 10-22. The answer of .005” less than the bolt recess is correct, don’t need all the other rabbit trails.
-
KKp321 replied to the thread Handguard mfg?.CDNN has a good selection of moderately prices handguards similar to the one pictured.
-
KDose parkerizing cause issues if press fit parts are disassembled first? Seems like the process would be easier in pieces then in one...
-
KKp321 replied to the thread 30 CARBINE BLACKHAWK CYLINDER REPAIR!!!.Hate to argue with the factory, but 180 grit lapping compound (not lashing, autocorrect got you I’ll bet) is very aggressive. I have...
-
KKp321 reacted to GeoDudeFlorida's post in the thread 45 ACP and Unique and the Lyman Manual with Like.
The fines - a.k.a. Bullseye. 🤣 The old rumors were that Bullseye was floor sweepings of Unique production; back in the L-R days, before...
-
KKp321 replied to the thread REM 770 serial search..The date code is not incorporated in the s/n. The code is small numbers stamped near the proof mark on the barrel shank. They can be...
-
KKp321 replied to the thread Garmin Xero C1 Pro Chronograph.I received mine from Brownells Thursday, ordered it before they sent out the notice saying they had them. I won’t share the price except...
-
-
Loading…
-
Loading…
-
Loading…