-
-
Llordpaxman replied to the thread Tip: Keeping Used Load Development Targets.I use quadrille ruled paper, 8 12/ X 11 with the three holes punched. It feeds through a printer so I can print the load information...
-
Llordpaxman reacted to maxxhavoc's post in the thread Tip: Keeping Used Load Development Targets with
Like.
Over the years, I have standardized on SR-1c (or SR-21c) targets for load development and most shooting. Keeping these together with... -
Llordpaxman replied to the thread Help a Newbie.Welcome to THR. I hope you’re keeping good notes, there’ll be a test later… Titegroup is a good powder, very fast, but it’s got a high...
-
LCurrently, I only have Titegroup and H110. I just found some CFE Pistol, so I’ll grab that while I can. Still building up my powder...
-
Llordpaxman replied to the thread Chronograph Sample Size Comparison & Statistical Analysis.I’ve only started precision .22 so I’m just following along as very interested. This is impressive or insane or both! You’re talking...
-
LI grew up watching my Dad reload for many years. I've recently decided to finally make the time to get back into it myself. Problem...
-
LAnd how do we know that? I don't think your assertion is correct. Practically all sampling schemes require that the process be stable...
-
LI ordered the 200’s for the RSBH. I figure they will be fine in the 77/44 if I decide to try them. The problem with where this is going...
-
Llordpaxman replied to the thread Variance of velocity on reloads??.It’s an exercise to estimate sample size for a population. I’m with you on the handgun accuracy part, but I do use my SD numbers for...
-
LYour only a victim if you claim statistical victory. Good enough reloading isn't going anywhere....
-
L😳😳 I'm gonna quit reloading if I gotta relearn Math again. 😁
-
Llordpaxman reacted to Varminterror's post in the thread Variance of velocity on reloads?? with Like.
Something of note - not picking on @Theinkman here, just using his data as one of hundreds of instances I've seen posted online - ANY...
-
LI made a custom hole saw to cut my nitro cards. Took a brass 30-06 case with the primer removed cut it down about the length of the full...
-
LIt's a gasket/hole punch. Also used in leather craft. They come in all sizes, some have interchangeable heads. I've think I seen them at...
-
LYes, they had run out before I got around to 45 acp. So I annealed an extra size die I had and machined it. After sizing I also...
-
-
Loading…
-
Loading…
-
Loading…